Central Machinery 60564 Owner's Manual & Safety Instructions page 10

Wiring Motor
1. After the power cord is unplugged, remove
the Screws (23) from above and below the
Power Switch (28) to release the Switch Plate (28-1).
NOTE: Slide the Power Switch up to access the
bottom Screw, if needed. See Figure 13, right.
2. Inside the stand, move the Switch Cover
slightly to the side to allow access.
3. Insert the motor cord through the hole in the side
of the Switch Cover (13A). See Figure 14, below.
4. The power cord wires are already connected at the
bottom connections (black "hot" wire, white "neutral"
wire, and green ground wire). Connect the wires
from the Motor above the wires of the same color,
black with black, white with white, and green with
green. The green wire is attached to the screw
to the right of the Switch. See Figure 14, right.
WARNING! TO pREVENT ELEcTRIc
SHOcK, FIRE AND DEATH:
It is critical that the GREEN ground wire
is attached to the terminal OUTSIDE the
switch box and that ONLy the GREEN
wire is attached outside the switch box.
The included terminals are designed to
reduce the risk of improper wiring;
DO NOT MODIFy, REpLAcE OR FORcE
THE TERMINALS.
If you have any doubt about your ability to
connect the motor wires safely and securely,
have a certified electrician connect the wiring.
5. After the wiring is properly connected,
carefully hold the Switch Cover in place
and secure in place with the Screws.
Page 10
TO pREVENT ELEcTRIc SHOcK AND DEATH
FROM INcORREcT GROUNDING WIRE cONNEcTION,
READ AND FOLLOW THESE INSTRUcTIONS:
For technical questions, please call 1-800-444-3353.
Figure 13
Screw
(23)
Power
Switch
(28)
Figure 14
Black
Black
Power
Cord
(20)
Switch
Plate
(28-1)
White
Green
Green
White
Item 60564