Push Stick; Inspection, Maintenance, And Cleaning - Central Machinery 45804 Assembly And Operating Information

Brought to You by Augusta Flint
move the left hand safely away from the workpiece and the Saw Blade (3). Then,
continue pushing the workpiece into the Saw Blade, with the Push Stick, until the
cut is complete. (See Figure O.)
7. Once the cut is complete, continue to maintain control of the workpiece. Turn
the Power Switch (179) to its OFF position. Then, wait until the Saw Blade (3)
completely stops rotating before removing the workpiece.
BLADE GuARD ASSY. (50)
SAW BLADE (3)
WORKPIECE
CuT LINE

PuSH STICK (37)

TABLE SAW OVERLOAD PROTECTION
1. The Table Saw is equipped with a Circuit Breaker (178).
If the motor shuts off or fails to start due to overloading
(cutting stock too fast, using a dull Saw Blade (3), low
voltage, using the Table Saw beyond its capacity, etc.),
turn the Power Switch (179) to its OFF position. Let the
motor cool three to five minutes, and push the Circuit
Breaker button which will reset the overload device.
The motor can then be turned on again in the usual
manner. (See Figure P.)

INSPECTION, MAINTENANCE, AND CLEANING

1. WARNING! Always disconnect the Table Saw from its electrical pow-
er supply source before performing any inspection, maintenance, or
cleaning procedure.
2. Before each use, inspect the general condition of the Table Saw. Inspect switch,
power plug and cord assembly, and extension cord (if used) for damage. Check for
loose screws, misalignment, binding of moving parts, broken, cracked, or improper
mounting of the Saw Blade (3), broken parts and any other condition that may affect
its safe operation. If abnormal noise or vibration occurs, turn off the Table Saw
immediately and have the problem corrected before further use.
SKU 45804
Do not use damaged equipment.
PAGE 16
NOTE:
TOP VIEW OF TABLE
FENCE ASSY. (75)
FIGuRE O
FIGuRE P