Blinks Error Code - Panasonic TC-P42X1 Revised Troubleshooting Handbook

11 Blinks Error Code (Full-HD Models Only)
If the power LED continues to blink even after the TV is unplugged, press and hold the power
switch on the TV for a few seconds until the LED turns off.
Trouble Mode
Fan SOS
NOTE A: Use a piece of wire, the size of a ¼ watt resistor's leads as a jumper.
FAN CONNECTOR
A
Fan
Connector
Defective Board (Possibility)
Fans, A Board, Connections
JUMPER WIRE
Warning: Disconnect AC Power prior to making any
disconnection or connection
Make sure that connector A30 is properly seated
BLACK PLUG
Unplug the TV and disconnect the connector from
Fan A. Place a jumper wire (NOTE "A") between the
center pin (Black wire) and the pin with the yellow
wire on the black plug. Plug in the TV and press the
B
Fan
Connector
connector from Fan B. Place a jumper wire (NOTE
"A") between the center pin (Black wire) and the pin
Replace
Start Here
power switch
Does the
Yes
TV power
up and
stay on?
Replace
Fan A
Unplug the TV and reconnect Fan. Disconnect the
with the yellow wire on the black plug. Plug in the
TV and press the power switch
Does the
Yes
TV power
up and
stay on?
Fan B
No
No
Replace
The A board
Slide #61