Blinks Error Code (50" Hd Models) Flowchart - Panasonic TC-P42X1 Revised Troubleshooting Handbook

6 Blinks Error Code (50" HD Models) Flowchart

If the power LED continues to blink even after the TV is unplugged, press and hold the power
switch on the TV for a few seconds until the LED turns off.
LIST OF MODELS: TC-P50X1
Verify that all the cables plugged in to the SC and SS boards are properly seated. Also check the ribbon cables and connectors on the A and C
boards. Unplug the TV and disconnect connector SC20 on the SC board. Plug in the TV and turn it on
Unplug the TV and disconnect
connector SC20 on the SC board,
SS11 on the SS board and C10 on the
C1 board. Plug in the TV and turn it on
Yes
Is the power
LED still
blinking?
Replace
the A board
The SU or/and the SD Boards can be
defective. Follow procedure on slides
17~21 to determine which of the 2 boards
is defective.
TC-P50C1
6 times
No
Unplug the TV and reconnect
connectors SC20, SS11, and C10.
No
(Follow the SU/SD boards
isolation procedure shown on
slides 17~19). Plug in the TV and
press the power switch
Does the
Yes
TV power
up and
stay on?
CAUTION: The TV power should not be turned on while
TC-50PX14
SC2 is disconnected. This could damage the SS board.
Start Here
Did the
Yes
number of
blinks
change?
No
Replace
Replace
the SS and
the SC board
A boards
Replace
8 times
the SS board
10 times
NOTE: The SS board may had just
become damaged (Shorted Vsus).
Unplug the TV. Keep SC20
disconnected and disconnect connector
SS11 on the SS board and C10 on the
C1 board. Plug in the TV and turn it on
Yes
Is the
power
LED still
blinking?
No
Replace
the SS and
SC boards
Slide #43