Blinks Error Code (42" Hd Models) Flowchart - Panasonic TC-P42X1 Revised Troubleshooting Handbook

6 Blinks Error Code (42" HD Models) Flowchart

If the power LED continues to blink even after the TV is unplugged, press and hold the power
switch on the TV for a few seconds until the LED turns off.
LIST OF MODELS: TC-P42X1
Verify that all the cables plugged in to the SC and SS boards are properly seated. Also check the ribbon cables and connectors on the A
and C boards. Unplug the TV and disconnect connector SC20 on the SC board. Plug in the TV and turn it on
Unplug the TV and reconnect
connectors SC20. (Follow the
SU/SD boards isolation procedure
shown on slides 17~19). Plug in
the TV and press the power
switch
Does the
Yes
TV power
up and
stay on?
The SU or/and the SD Boards
can be defective. Follow
procedure on slides 17~21 to
determine which of the 2 boards
is defective.
TC-P42C1
Yes
Replace
the A board
No
the SS and
A boards
Replace
the SC board
CAUTION: The TV power should not be turned on while
TC-42PX14
SC2 is disconnected. This could damage the SS board.
Start Here
Does the
No
TV power
up and
stay on?
No
number of
6 times
change?
6 times
8 times
Replace
10 times
Replace
the A board
the SS board
Did the
Yes
10 times
blinks
Unplug the TV and with SC20 still
disconnected, disconnect SS11 on
the SS board. Plug in the TV and
Yes
Is the power
LED still
blinking?
Replace
8 times
turn it on.
No
Replace
the SS and SC
boards
Slide #42