Avaya 3616 Installation Manual page 27

• SVP-II Master
The master AVPP must be identified in an IP system. Select one of the following identification
options:
• To statically configure the IP address of the master AVPP in each of the AVPP's, enter
the IP address.
• To statically configure the IP address of the master AVPP in a DHCP server and
configure each of the AVPP's to get the information from the DHCP server, enter DHCP. If
DHCP is used, the IP address of the master AVPP server must be configured in the
DHCP server. For more information about DHCP integration factors, see the wireless
phone interface guide for your IP environment.
• To statically configure the IP address of the master AVPP in a DNS server and configure
each of the AVPP's to retrieve this information from the DNS server, enter DNS. If DNS is
used, the IP address of the master AVPP server must be configured in the DNS server.
For an explanation of the master AVPP, see Introduction to AVPP.
• First Alias IP Address/Last Alias IP Address
Enter the range of IP addresses this AVPP may use when acting as a proxy for the wireless
phones. Alias IP addresses are not necessary in Avaya systems.
•
Note
All alias addresses must be on the same subnet as the AVPP server and cannot be
duplicated on other subnets or AVPP's. There is no limit to the number of addresses that
can be assigned, however, the capacity of each AVPP is 500 wireless phones.
• Enable H.323 Gatekeeper
This function is not supported. Enter N (No).
• Ethernet link
The AVPP will auto-negotiate unless there is a need to specify a link speed.
• System Locked
This option is used to take the system down for maintenance. The default entry is N (No). To
prevent any new calls from starting, set as Y (Yes). To restore normal operation, return to N.
•
Maintenance Lock
The system automatically sets this option to Y (Yes), after certain maintenance activities that
require reset (such as changing the IP address). Maintenance Lock prevents any new calls from
starting. This option is automatically set by the system and cannot be changed by the system
administrator. To clear the Maintenance Lock, reset the system at exit.
• Inactivity Timeout (min)
Set the number of minutes the administrative module can be left unattended before the system
closes it. This number can be from 1 to 100. If it is set to zero (0), the administrative module will
not close due to inactivity.
• QoS Configuration
Select this option to set the DSCP tags and the 802.1p tags. See QoS Configuration.
• Reset System
If this option is selected, you will be prompted to reset the AVPP upon exiting this screen.
Resetting the AVPP will terminate any calls in progress.
3600 Series IP Phone Installation
IP Office 4.0
2. AVPP Installation and Configuration
15-601082 Issue 05a (22nd May 2007)
Page 27