V I I I . B A T T E R I E S A N D C H A R G I N G; Charging The Batteries - Pride Mobility Jet1 Owner's Manual

Power chairs
Hide thumbs Also See for Jet1:
Table of Contents

Advertisement

V I I I . B A T T E R I E S A N D C H A R G I N G

BATTERIES
Your Jet 1 uses two long-lasting, 12-volt, deep-cycle batteries. These batteries are sealed and maintenance-free.
Since they are sealed, there is no need to check the electrolyte (fluid) level. Deep-cycle batteries are designed to
handle a longer and deeper discharge. Though they are similar in appearance to automotive batteries, they are not
interchangeable. Automotive batteries are not designed to handle a long, deep discharge, and also are unsafe for
use in power chairs.
WARNING! Battery posts, terminals, and related accessories contain lead and lead compounds.
Wash hands after handling.

CHARGING THE BATTERIES

The battery charger is essential in providing long life for your Jet 1 batteries. See figure 26. The battery charger is
designed to optimize your Jet 1’s performance by charging the batteries safely, quickly, and easily. The charging
system consists of the battery charger, the charger fuse, and the ammeter. See figures 26 and 27. The onboard
charger is located underneath the utility tray. The ammeter is located on the utility tray for easy viewing. The charger
has an in-line fuse that protects the ammeter. The ammeter indicates the rate of charge necessary to fully recharge
the batteries. It is also a good indication of whether or not the charger is working. The ammeter and the charger are
only functional when the charger power cord is plugged into a wall outlet.
WARNING! Never use an extension cord to plug in your battery charger. Plug the charger directly
into a properly wired standard wall outlet.
NOTE: You must recharge your Jet 1’s batteries with the supplied onboard or the supplied off-board charg-
ing system. Do not use an automotive-type battery charger.
To charge the batteries using the onboard charger:
1. Position the rear of your Jet 1 close to a standard wall outlet.
2. Be certain the controller power is turned off and the freewheel levers are in the engaged position. See III. “The
Jet 1.”
3. Remove the battery charger cord from the back pouch of your Jet 1 and plug it into the battery charger power
outlet located on the utility tray. See figure 27.
BATTERY
CHARGER
Figure 26. Onboard Battery Charger
24
CHARGER
FUSE
BATTERY CHARGER
POWER OUTLET
Figure 27. Utility Tray
AMMETER
Jet 1

Advertisement

Table of Contents
loading

Table of Contents