Table of Contents
Advertisement
UTILITY TRAY
The utility tray is located on the rear of your Jet 1. The utility tray is exposed through the body shroud. The utility
tray consists of the battery charger power cord outlet, the ammeter, the main circuit breaker, and the joystick
controller harness connectors.
n Ammeter: The ammeter displays the charger’s current output in amps. See figure 4. For more information,
see VII. “Operation.”
n Battery charger power cord outlet: This is where your battery charger power cord plugs in. See figure 4.
The battery charger power cord is not attached to the unit at all times. See figure 3. For more information, see
VIII. “Batteries and Charging.”
n Main circuit breaker: The main circuit breaker is a safety feature built into your Jet 1. See figure 4. When the
batteries and the motors are heavily strained (e.g., from excessive loads), the main circuit breaker will trip to
prevent damage to the motors and the electronics. If the circuit trips, allow your Jet 1 to “rest” for approximately
one minute. Next, in the circuit breaker button, turn on the joystick controller and continue normal operation. If
the main circuit breaker continues to trip repeatedly, contact your authorized Pride provider.
n Joystick controller harness connectors: This is where the joystick connects to the motors, batteries, and
charger. If your Jet 1 is equipped with a Dynamic DL controller, there are two connectors on the tray. See
figure 4.
BATTERY CHARGER
POWER CORD OUTLET
Jet 1
I I I .
T H E
Figure 4. Utility Tray
J E T
AMMETER
MAIN CIRCUIT BREAKER
1
JOYSTICK CONTROLLER
HARNESS CONNECTORS
11
Advertisement
Table of Contents
