Table of Contents
Advertisement
To reduce the possibility of shipping damage, your Jet 1’s seat is removed from the power base, and the seatback is
removed from the seat assembly before your Jet 1 is shipped. The joystick may have also been removed from the
armrest. The following is a set of instructions to help you quickly and easily prepare your Jet 1 for immediate use.
Required Tool: Phillips screwdriver
Parts List
Phillips-head seatback mounting screws
Knobs - arm width adjustment
Expandable arm
Expandable arm with joystick
Seatback
20 cm wire ties
SEATBACK ASSEMBLY
The seatback mounts to the back hinges with four (4) Phillips-head screws. To get to the hinges, lift up the reusable
fasteners flap which covers them in the back. You may install the seatback before or after you install the seat to the
power base.
To mount the seatback to the hinge:
1. Line up the hinges with the holes in the seatback. See figure 7.
2. Insert the Phillips-head screws through the hinge and into the seatback.
3. Tighten the four screws.
Jet 1
I V .
A S S E M B L Y
Quantity
4
2
1
1
1
4
Figure 7. Seatback Assembly
PHILLIPS-HEAD
SCREWS
13
Advertisement
Table of Contents
