Table of Contents
Advertisement
V .
C O M F O R T
3. Slide the leg rest in or out to the desired length.
4. Tighten the bolt and reinstall the two screws on each leg
rest extension.
ANTI-TIP WHEEL ADJUSTMENT
The anti-tip wheels are designed to give your Jet 1 increased
stability on rough surfaces. The anti-tip wheels are preset at
the factory to a height of 2 cm off of the ground. This setting
is for smooth surfaces or indoor use only. If you plan on using
your Jet 1 on rough surfaces, it may be necessary to adjust
the anti-tip wheels to better suit your needs.
The anti-tip wheels may need adjustment if either of the fol-
lowing occur:
n When coming to a stop, your Jet 1 tips forward excessively.
n The anti-tip wheels constantly rub the ground.
Required Tool: 13 mm wrench
NOTE: Each drive tyre must have at least 30 lbs. of air
pressure in order for the anti-tip wheels to be properly
adjusted.
To adjust the anti-tip wheels:
1. Remove the seat and body shroud.
2. Adjust the 13 mm anti-tip adjustment nut so that the anti-
tip wheel is 1,2 cm to 2,5 cm off of the ground. Turn the
nut clockwise to raise the anti-tip wheel and counterclock-
wise to lower the anti-tip wheel. See figure 22.
NOTE: The higher you raise the anti-tip wheels, the more
tendency your Jet 1 will have to tilt forward when coming
to a stop. You can compensate for this by making a small
adjustment to the preprogrammed deceleration setting in
the controller.
Jet 1
A D J U S T M E N T S
Figure 20. Elevating Leg Rests
LEG REST
ADJUSTMENT BOLT
Figure 21. Elevating Leg Rests
LEG REST ADJUSTMENT SCREWS
ANTI-TIP ADJUSTMENT NUT
Figure 22. Anti-tip Adjustment
RELEASE LEVER
19
Advertisement
Table of Contents
