Table of Contents
Advertisement
SEAT INSTALLATION
To install the seat:
1. Set the seat on the seat tower. See figure 8.
2. Push the seat down until the latch engages. See figure 9.
3. Plug the controller harness into the connector on the utility
tray. See figure 10A.
CHARGER INHIBIT PLUG CONNECTION
The charger inhibit connector, located on the utility tray, is coded
with coloured dots. The dots are positioned so that the flat side
of the male connector aligns with the flat side of the female
connector while making the connection. See figure 10B.
WARNING! Failure to properly align the con-
nectors can result in damage to the control-
ler, the charger, the charger harness, and the
connectors.
JOYSTICK INSTALLATION
If your Jet 1 is equipped with a Dynamic DL joystick control-
ler without the power seat option, it may have been shipped
without the joystick installed in the armrest. See figure 11.
To install the joystick controller:
1. Use a 3/16-in. hex key to loosen the setscrew. See figure 12.
2. Slide the joystick mounting bracket into or out of the arm-
rest to the desired position.
3. Retighten the setscrew by turning it clockwise.
14
I V .
A S S E M B L Y
Figure 8. Seat tower
Figure 9. Seat Installation
Figure 10A. Controller Harnesses
PLUG IN CONTROLLER HARNESSES
Jet 1
Advertisement
Table of Contents
