Comfort Adjustments; Armrest Width Adjustment - Pride Mobility Jet1 Owner's Manual

V . C O M F O R T
After you have become familiar with your Jet 1’s operation,
you may find the need to adjust the seat. There are some
adjustments you can make to increase your comfort, such as
seat height and angle, armrest height and angle, footrest height
and angle, and joystick position.
CAUTION! If your Jet 1 was configured at
your authorized Jet 1 provider, please con-
sult your health care professional before
changing the seat position or making any
other adjustment. Some adjustments may
degrade your Jet 1’s performance and
safety by changing its center of gravity.
SEAT HEIGHT AND ANGLE
You can change the seat height manually.
To change the seat height:
1. Remove the seat. See VI. “Disassembly.”
2. Remove the nut and bolt from the seat tower. See figure 13.
3. Raise or lower the seat tower to the desired position.
4. Install the nut and bolt into the seat tower.
5. Install the seat.
You can change the seat angle by either raising or lowering
the seat towers (front or rear).

ARMREST WIDTH ADJUSTMENT

To change the armrest width:
1. Locate the two setscrews on the armrest receiver
bracket. See figure 14.
2. Loosen the setscrews and slide the armrests in or out
to the desired width.
3. Tighten the setscrews.
16
A D J U S T M E N T S
Figure 13. Seat Tower Nut And Bolt
Figure 14. Armrest Width
LOOSEN SETSCREWS TO MOVE ARMREST
NUT AND BOLT
Jet 1