Lighting Instructions; Shut Down - Napoleon OS10 Installation And Operation Instructions Manual

LIGHTING INSTRUCTIONS

Proceed once installation is complete and all necessary instructions have been followed:
When lit for the first time, the stove will emit a slight odour for a few hours. This is a normal temporary condition
caused by the curing and the "burn-in" of internal paints and lubricants used in the manufacturing process and
will not occur again. After extended periods of non-operation such as following a vacation or a warm weather
season, the stove may emit a slight odour for a few hours. This is caused by dust particles burning off. In both
cases, open a window to sufficiently ventilate the room.
1. Through the
(items C, D and E, figure 10) from the burner.
2. Ensure that the burner pot is dry, and clean with no oil remaining.
FIGURE 12
6. Allow 10 to 15 minutes of low burn for the flames and chimney draft to stabilize. The catalyser should glow
red before changing to a higher setting.
7. The stove may now be adjusted to the desired heat setting, usually between 2 and 4. Never switch straight
from 1 to 6. A longer burner life will be achieved if the regulator is moved one setting at a time leaving approx.
5 minutes between settings.
If the fire goes out, return the regulator control knob to the '0' setting. Let the burner cool off completely before
repeating the lighting procedure. Clean out any oil before relighting.
NEVER OPERATE THE STOVE WITH THE DOOR OPEN OR AJAR.

SHUT DOWN

1. Turn the control knob to 0 setting.
2. Lift the safety lever.
3. Turn off the oil tank fuel supply valve.
The oil tank fuel supply valve should always be shut if the oil stove is not in operation.
open door, remove
firestarter gel (methane pellet or
paraffin paper or 2 tablespoons of methylated spirits) into the
burner pot.
FIRESTARTER.
ately replace the catalyser components. FIGURE 10. Ensure
that the top is centred.
to allow oil flow into the regulator. FIGURE 12.
the catalyser components
3. Place a piece of thumb nail size
NEVER USE ALCOHOL OR GASOLINE AS A
Light with a long taper or wadded piece of paper. Immedi-
4. Set the control knob to '0'. FIGURE 11. Depress safety lever
5. Turn the regulator control knob to the # 1 dial setting.
FIGURE 11
9