Table of Contents
Advertisement
MAINTENANCE
WEEKLY - DESCALE
Push and pull the de-scaling lever in and out as well
as turning slightly at the same time completely two or
three times. Push in for normal burner operations or
before relighting.
EVERY 3 TO 4 MONTHS - CLEAN BURNER
Remove all three catalyser components. FIGURE 10.
Remove any carbon residue and remaining oil from the burner
using a slightly damp cloth. Buff dry before reinstalling.
YEARLY - CLEAN CARBURETOR FILTER
1. Set the control knob to 0.
2. Turn off oil supply at the valve or the tank valve.
3. Raise the safety lever (D).
4. Place a container under the carburetor to contain any spillage. Remove
the filter plug held on with two screws.
5. Pull out the filter (E) and clean in oil using a soft brush. Never use a wire
brush.
6. Replace filter and plug.
Clean all enamelled stove panels and the outside of the glass using a slightly
dampened cloth. Never clean when the stove is hot
CHIMNEY INSPECTION AND MAINTENANCE
The chimney and the chimney connector must be inspected at least once every 3 months during the heating
season to ascertain whether there has been a buildup of soot in the system. If a soot buildup has occurred, it
should be removed to reduce the risk of chimney fires. The chimney is to be swept at least once a year. It is also
recommended that prior to every heating season the entire system be professionally inspected, cleaned and
repaired where necessary.
FIGURE 13
D
E
F
G
H
A - control knob
B - thermostat control
C - oil level regulator
D - safety lever
E - filter
F - main float
G - safety float
H - filter cavity
11
A
C
B
Hide quick links:
Advertisement
Table of Contents
