Table of Contents
Advertisement
(b) When the following menu is displayed, select a required setting value from 5m , 5-10m ,
10 -m by turning [JOG DIAL] and end the operation by pressing [ACQ/ENT].
9.7.6 Setting a gyro value [MENU] [AZI MODE]
After connecting an optional NSK unit, set a master gyro value in the NSK unit.
The GPS compass JLR-10 of JRC always can output absolute azimuth without
gyro setting.
Therefore, do not set a gyro value when connecting JLR-10.
Use the following procedure to set a gyro value.
Use the following procedure to set a gyro value.
Use the following procedure to set a gyro value.
Use the following procedure to set a gyro value.
(a) Display the INSTALLATION menu by pressing the [MENU] key in long mode, select
GYRO SETTING , and press [JOG DIAL] or [ACQ/ENT].
(b) After setting the gyro value that was read from the master gyro by turning [JOG DIAL],
end the operation by pressing [JOG DIAL] or [ACQ/ENT].
(c) For operation (a), the menu can be opened directly from [AZI MODE]. When the [AZI
MODE] key is pressed in long mode, the initial menu is displayed. Subsequent operation
is the same as for (b).
RADAR ADJUST2
MBS LVL
MBS RNG
GAIN PRESET
ANTENNA HEIGHT
5m
5-10m
10-m
159
Ｇ Ｇ Ｇ Ｇ Ｙ Ｙ Ｙ Ｙ Ｒ Ｒ Ｒ Ｒ Ｏ Ｏ Ｏ Ｏ
Ｓ Ｓ Ｓ Ｓ Ｅ Ｅ Ｅ Ｅ Ｔ Ｔ Ｔ Ｔ Ｔ Ｔ Ｔ Ｔ Ｉ Ｉ Ｉ Ｉ Ｎ Ｎ Ｎ Ｎ Ｇ Ｇ Ｇ Ｇ
0 0 0 0 3 3 3 3 4 4 4 4 5 5 5 5
Advertisement
Table of Contents
