When Not Using A Dedicated Cable - JRC JMA-5104 Instruction Manual

To input NMEA data such as position information from the GPS equipment of JRC or a
different manufacturer by acquiring azimuth data from JLR-10, connect a cable from GPS
equipment using the connection method that is described in 9.3.9, "Connecting a GPS receiver
and NMEA equipment" or using a reserved cable, P3. Do not use the cable from JLR-10,
which is inserted in GPS(J3) input, as shown in Photograph 3.

2. When not using a dedicated cable

To connect azimuth information data from a GPS compass, use J5 8-pin connector P5
(LTWD09BFFA-L180) that is included in the main unit package.
See below for the connection method.
Signal name
Compass data input+
Compass data input−
Compass data output+
Compass data output−
GND
The above information is related to the connection of azimuth data for JLR-10 only. For
position information, use the method that is described in 9.3.9, "Connecting a GPS receiver and
NMEA equipment".
GPS compass Connector of
connector side the equipment
NC
NC
RADAR-4
RADAR-3
RADAR-5
135
Photograph 3
Insert the 6-pin connector of
CFQ-6934 with GPS (IND)
label attached to the connector
of processing unit J3.
Insert the 9-pin connector of
CFQ-6934 with NSK(IND) label
attached to the connector of
processing unit J5.
J5-1
J5-2
J5-3
J5-4
J5-5