Suppressing The Power Consumption Of The Radar [Menu]; Using The Intermittent Transmitting Function [Menu]; Canceling The Intermittent Transmitting Function [Menu]; Setting The Period Of The Transmitting State (The Number Of Antenna Rotations) [Menu] - JRC JMA-5104 Instruction Manual

3.5.15 Suppressing the power consumption of the radar [MENU]

Use the intermittent transmitting function to suppress the power consumption.
The transmitting state and standby state are automatically switched while the intermittent
transmitting function is used.
The intermittent transmitting function can freely set the periods of the transmitting state and
standby state.
Period of the tran Period of the transmitting state Period of the tran Period of the tran
Period of the standby state → → → → Set the time while the standby state is placed. Period of the standby state
Period of the standby state Period of the standby state

1. Using the intermittent transmitting function [MENU]

Take the following steps to use the intermittent transmitting function:
(a) Press the [MENU] key to display MENU .
(b) Select TX PLAN and then TX PLAN pressing the [JOG DIAL] or [ACQ/ENT] key
after each selection.
(c) The menu below is displayed. Turn [JOG DIAL] to select ON , and then press the [JOG
DIAL] or [ACQ/ENT] key to determine the selection.
When the intermittent transmitting function is turned ON, the transmitting state is placed
only while the antenna rotates the preset number of times. Similarly, the standby state is
placed only during the set time.

2. Canceling the intermittent transmitting function [MENU]

In step (c) above, select OFF , and then press the [JOG DIAL] or [ACQ/ENT] key to determine
the selection.
Caution
● ● ● ● Cancelling is possible only when it is under transmitting state. It is not possible
under standby state.

3. Setting the period of the transmitting state (the number of antenna rotations) [MENU]

Take the following steps to set the number of antenna rotations:
(a) Press the [MENU] key to display MENU .
(b) Select TX PLAN and then TX PERIOD pressing the [JOG DIAL] or [ACQ/ENT] key
after each selection.
(c) The menu below is displayed. Turn [JOG DIAL] to set the number of antenna rotations
for placing the transmitting state, and then press the [JOG DIAL] or [ACQ/ENT] key to
determine the setting.
smitting state → → → → Set the number of times the antenna rotated. smitting state smitting state Set the number of times the antenna rotated. Set the number of times the antenna rotated. Set the number of times the antenna rotated.
Set the time while the standby state is placed.
Set the time while the standby state is placed. Set the time while the standby state is placed.
TX PLAN
OFF
ON
TX PLAN
OFF
10 SCAN
3 MIN
65