Setting The Period Of The Standby State [Menu] - JRC JMA-5104 Instruction Manual

When the period of the transmitting state is set, the transmitting state is placed only while the
antenna rotates the set number of times and then automatically switched to the standby state.
After the standby state is placed for the set time, it is switched to the transmitting state again.
Likewise, the two states are switched back and forth repeatedly.

4. Setting the period of the standby state [MENU]

Take the following steps to set the period of the standby state:
(a) Press the [MENU] key to display MENU .
(b) Select TX PLAN and then STBY PERIOD pressing the [JOG DIAL] or [ACQ/ENT]
key after each selection.
(c) The menu below is displayed. Turn [JOG DIAL] to set the time for placing the standby
state, and then press the [JOG DIAL] or [ACQ/ENT] key to determine the setting.
When the period of the standby state is set, the standby state is placed only for the set time
and then automatically switched to the transmitting state. After the transmitting state is
placed while the antenna rotates the set number times, it is switched to the standby state
again. Likewise, the two states are switched back and forth repeatedly.
TX PLAN
TX PLAN OFF
TX PERIOD 10 SCAN
1～99 SCAN 3 MIN
TX PLAN
TX PLAN OFF
STBY PERIOD 10 SCAN
1～99 MIN 3 MIN
66