Installing And Display Unit; Setting Vertically Or Horizontally; Connecting Cables - JRC JMA-5104 Instruction Manual

9.3.5 Installing and display unit

Display unit NWZ-146 is connected with two cables.

1. Setting vertically or horizontally

A display unit can be installed vertically or horizontally.
When changing the orientation of a display unit from vertically to horizontally or vice versa,
remove the four small screws from the rear of the display unit and install it with the required
orientation as shown below.
Horizontal installation

2. Connecting cables

Connect two cables from the processing unit.
One cable is used as a video cable and the other is used as a power cable. As shown in the
photograph below, insert the two cables at the rear of the display unit, turn the plugs until
they stop, and check that the cables do not come off even if they are pulled.
(o: Brightness adjustment knob)
123
Vertical installation
Connection on the display
unit side :
Make sure that the cables do
not come off even if they are
pulled.