Preparing The Ups For Installing; Optional Cabinets Or Accessories - Powerware 9315 Installation Manual

Preparing the UPS for Installing

Optional Cabinets or Accessories

If you are installing optional cabinets or accessories, such as a Power Distribution
Module (PDM) cabinet, an input transformer cabinet, or a Remote Monitor Panel
(RMP), you must prepare the UPS cabinet for the installation of these options.
Refer to Figure 5 for the locations of the items mentioned in these procedures.
Also, refer to Powerware 9315 Series 685 and 1085 Auxiliary Battery Cabinets
Installation Manual, 164200300, for information on installing battery cabinets.
To prepare the UPS for joining to an input transformer, PDM, or both:
1.
Be sure the UPS is turned off and all power sources are removed. (See the
operator's manual for instructions.)
2.
Remove the left side panel of the UPS and set it aside.
3.
Open the doors of the UPS.
4.
Remove the air filters and set aside for later reuse.
5.
Remove the lower metal access panel (see Figure 5 for location). Set the
access panel and hardware aside for later reuse.
To prepare the UPS for wiring to an RMP , RIM, SCM, or Remote EPO:
1.
Be sure the UPS is turned off and all power sources are removed. (See the
operator's manual for instructions.)
2.
Open the doors of the UPS.
3.
Remove the air filters and set aside for later reuse.
4.
Remove the lower metal access panel (see Figure 5 for location). Set the
access panel and hardware aside for later reuse.
Powerware 9315 (100 kVA- -160 kVA) Installation
164200292 Rev. E 041500
13