This manual describes how to install your Powerware
Uninterruptible Power Supply (UPS) system. It contains instructions for
installing the UPS and each optional component and accessory. The information
you will use depends on the system you purchased.
Each component of your UPS system is housed in a free-standing cabinet. The
cabinets line up and match in style and color, and have safety shields behind the
doors for hazardous voltage protection. Figure 1 shows a sample UPS system that
includes at least one of each component.
PDM CABINET
(optional)
These basic UPS system configurations are possible:
·
The UPS and one or more battery cabinets
·
The UPS, battery cabinet(s), and a Power Distribution Module (PDM)
·
The UPS, battery cabinet(s), and an input transformer
·
The UPS, battery cabinet(s), PDM, and input transformer.
You can enhance any of these system configurations by adding optional accessories,
such as a Remote Monitor Panel (RMP), Relay Interface Module (RIM), or Remote
Emergency Power Off (EPO) control.
Powerware 9315 (100 kVA- -160 kVA) Installation
164200292 Rev. E 041500
INPUT
TRANSFORMER
CABINET
(optional)
Figure 1. Typical UPS System
Introduction
9315
UPS
CABINET
BATTERY
CABINET
(up to four)
1