DNS2
Description
Value Range
Default Value
Phone User Interface
Reference
Configuration File Reference
3.4.2 Ethernet Port Settings
This screen allows you to change the connection mode of the Ethernet ports and the VLAN settings.
Note
•
When you change the settings on this screen and click [Save], after the message "Complete" has been
displayed, the base unit will restart automatically with the new settings applied. If a unit is on a call
when "Complete" has been displayed, the base unit will restart after the unit returns to idle.
•
Incorrect settings may cause a network failure. In such a case, you cannot access the Web user
interface anymore. To access it again, you need to correct the speed/duplex settings (® see
2.1.2 Speed/Duplex Settings) or perform IP Reset (® see 2.1.4 IP Reset) through phone user
interface programming.
3.4.2.1 Link Speed/Duplex Mode
LAN Port
Description
Document Version
2011-01
Specifies the IP address of the secondary DNS server.
Note
•
This setting is available only when [Connection Mode] is set
to [Static].
Max. 15 characters ("n.n.n.n" [n=0–255], except "0.0.0.0",
"255.255.255.255", "127.0.0.1", etc.)
Not stored.
Configuring Settings from the Base Unit (KX-TGP550 only)/Handset
(Page 17)
USER_DNS2_ADDR (Page 156)
Selects the connection mode (link speed and duplex mode) of the LAN
port.
3.4.2 Ethernet Port Settings
Administrator Guide
67