Phone User Interface Programming; Phone User Interface Feature List And Direct Commands; Speed/Duplex Settings - Panasonic KX-TGP500 Administrator's Manual

2.1.2 Speed/Duplex Settings

2.1 Phone User Interface Programming

This section provides information about the features that can be configured directly from the base unit or
handsets, but that are not mentioned in the User Guide.
To enter direct commands, use the keys and soft keys on the base unit (KX-TGP550 only) or handset.
For details about the other available features, settings and key operations on the phone user interface, refer
to the User Guide on the Panasonic Web site (® see Introduction).

2.1.1 Phone User Interface Feature List and Direct Commands

The following table shows additional features programmable with direct commands. These commands are
hidden from end users.
Direct
Command
[#][5][3][0]
[#][7][3][0]
[#][7][3][1]
[#][7][3][9]
Available for KX-TGP550 only.
*1
If your phone system dealer does not allow you these settings, you cannot change them even though the unit shows the setting menu.
*2
Contact your phone system dealer for further information.
*3 Not displayed on the LCD of the unit.
2.1.2 Speed/Duplex Settings
You can select the connection mode (combination of link speed and duplex mode) of the LAN port and PC
port (KX-TGP550 only). You can select from the following values:
•
Auto (default)
•
10M/Full
•
10M/Half
•
100M/Full
•
100M/Half
For details about configuring the speed/duplex setting from the Web user interface, see 3.4.2.1 Link Speed/
Duplex Mode.
36 Administrator Guide
Speed/Duplex LAN port
PC port
Enable VLAN
VLAN setting *1*2
IP Phone
PC
IP Reset
*3
Terminal No.
Reset Web ID/Password
Feature
*1
VLAN ID
Priority
VLAN ID
Priority
*3
Ref.
Page 36
Page 37
Page 38
Page 39
Page 40
Document Version 2011-01