Installing Spacer Bar - RIDGID TS3612 Owner's Manual

Installing Spacer Bar

1. From the bag labeled "Spacer Caps"
remove only the following hardware:
2 Set Screws 10-32 x 7/16" long
From unlabeled bag assembly remove
the following:
2 Locking Plates
From among the loose parts find the fol-
lowing:
1 Spacer Bar
2. To determine how many shim washers
(shown on previous page) will be
needed, slide the reduced ends of the
spacer bar into the "T' slots of the front
and rear guide bars. Push the spacer
bar against the fence brackets and
toward the front of saw. If there is a gap
between the large diameter of the
spacer bar and the inside of the rear
guide bar, fill the gap with the appropri-
ate number of shim washers. Remove
the spacer bar and place the shim
washers over the reduced end of the
bar.
3. Thread one of the set screws into each
of the locking plates as shown.
4. Place one locking plate assembly over
each end of the spacer bar with the
bent legs pointing out as shown.
5. Slide the locking plates, set screw end
first, into the "T" slots in the front and
rear guide bars. Locate the spacer bar
approximately 4-1/2" in from the end of
the rear guide bar and parallel to the
side of the table.
6. Use a 3/32" hex wrench to tighten both
set screws while holding the bar in
place.
Locking Plate
Spacer Bar
Rear
Guide Bar
Push
Fill Gap With
Shim Washers
Set Screw
Locking
10-32 x 7/16"
Plate
Locking Plate
Assembly
Approximately 4-1/2"
3/32" Hex Wrench
33
Set Screw
10-32 x 7/16"
Spacer
Front
Bar
Guide Bar
3/32" Hex Wrench
Shim Washers
(If Needed)
Spacer Bar
Rear Guide
Bar
Shim Washers
(If Needed)
Spacer Bar
"T" Slot
Spacer
Parallel
Bar