Mounting Your Saw - RIDGID TS3612 Owner's Manual

Mounting Your Saw

1. From the bag labeled "Legs" remove
the following hardware:
4 Hex Head Screws, 5/16-18 x 1-1/4"
Long
4 Hex Nuts, 5/16-18
4 Lockwashers, 5/16" External Type
8 Flat Washers, 11/32 x 11/16 x 1/16
2. Place the saw upside down onto a
smooth piece of cardboard or heavy
paper, on the floor, so the saw is resting
on the table top.
WARNING: The saw is heavy. To
reduce the risk of back injury, get
help to lift the saw. Hold the saw
close to your body. Bend your
knees so you can lift with your
legs, not your back.
3. Place legs on saw so that holes in saw
base and leg set line up and trim label
is facing front.
4. Install screw, washers, lockwasher and
nut as shown.
5. Tighten all leg assembly and mounting
hardware at this time.
Hex Nut
Lockwasher
Flat Washer
End Stiffener
Flat Washer
Hex Head Screw
Bench Mounting
If you do not use the legset and mount the
saw on a bench, make sure that there is
an opening in the top of the bench the
same size as the opening in the bottom of
the saw so that the sawdust can drop
through. Recommended working height is
33 to 37 inches from the top of the saw
table to the floor.
Leg Set
Saw Base
5/16-18 x 1-1/4 In
Hex Head Screw
5/16 In External
Lockwasher
Cardboard
7/8
+
15-3/4
+
Front of Saw
NOTE: All dimensions in inches
19
5/16-18
Hex Nut
11/32 I.D.
Flat Washer
7/16 Dia.
Mounting Holes
11-1/4
+
13
Bench
Opening
16-3/4
+
1/2