Checking Table Insert - RIDGID TS3612 Owner's Manual

WARNING: Table extensions
must be installed. Front edge of
table and extensions must be
lined up. An uneven front edge
can twist the fence guide bar.
Twisted guide bars can misalign
fence. A misaligned fence can
cause binding or kickback. You
could be hit or cut.
8. Tighten a "C" clamp over the edge of
table and extension at the center until
the extension is even with the table sur-
face as shown. Tighten the two center
nuts with a 1/2" wrench.
9. Repeat steps 7 and 8 to align the other
extension.

Checking Table Insert

WARNING: To reduce the risk of
injury from accidental start, make
sure switch is "OFF" and plug is
not connected to power source
outlet.
1. Insert should be flush with table top.
Check as shown. Loosen flat head
screw that holds insert and adjust the
four set screws as necessary. Tighten
flat head screw. Do not tighten screw to
the point where it bends the insert.
CAUTION: Insert must be even
with the table surface. Inserts too
high or low can let the workpiece
"snag" or catch on uneven
edges. Workpiece could twist
and kickback.
2. To remove insert.
a. Make sure saw is off and unplugged.
b. Loosen flat head screw.
c. Lift insert from front end, and pull
toward front of saw.
d. To replace insert.
e. Make sure saw is off and unplugged.
f. Place insert into insert opening in table
and push toward rear of saw to engage
spring clip and until keyslot in insert will
drop over flat head screw. Tighten
screw.
g. Do not tighten screw to the point where
it bends the insert.
"C" Clamp
3/32 In.
Hex "L" Wrench
Flat Head
Screw
21
Table Insert
Set Screws