Mounting Switch And End Caps; Installing Guide Bar End Caps; Securing Electrical Cords - RIDGID TS2424 Owner's Manual

Assembly (continued)

Mounting Switch and End Caps

1. From the bag labeled "Miscellaneous" remove only the
following hardware:
2 Pan Head Screws, 10-32 x 3/8" Long
2 Lockwashers, #10 External Type
2 Square Nuts, 10-32
4 Pan Head Screws, Type "AB" 8 x 1/2" Long
2 Rear Stop Washers
From the bag labeled "Trim" remove the following:
4 Plastic End Caps
1 Key Switch
2. Insert the 2 10-32 x 3/8" pan head screws with lock-
washers through the outermost holes in switch assem-
bly.
3. Install the 2 square nuts on the screws so that there is
an 1/8"+ clearance between the inside of the nut and
the top of the switch assembly bracket.
4. Slide the nuts into the lower slot of the front guide bar
from the right end, with the switch facing front.
5. Slide switch assembly left until the left side of switch
assembly is in line with right side of main saw table -
tighten screws.

Installing Guide Bar End Caps

1. The left and right end caps for front guide bar can be
installed at this time. Align the plastic end cap to match
profile of bar.
2. Install self tapping 8-32 pan head screw into each hole.
3. The left and right end caps for rear guide bar can be
installed at this time.
NOTE: Two large washers are supplied. These act as
fence stops so the rear of the fence does not fall off the
rear guide bar.
4. Install rear end caps and fence stops as shown.

Securing Electrical Cords

1. From the bag labeled "Large Parts" find the following:
2 Wire Ties
2. Route motor cord and power cord along right side of
cabinet. Use a hammer to lightly tap the pointed tabs
on the wire ties into the holes provided on side of cabi-
net. Secure both cords in wire ties.
NOTE: This completes the assembly of your table saw.
Do not throw away any remaining hardware until you
have read the entire owners manual.
Pan Head Screw
10-32 x 3/8"
Type "AB" 8 x 1/2
Pan Head Screw
10-32
Square Nut
Rear Stop Washer
Square Nut
Key Switch
Front Guide
Bar
Switch Assembly
Front End
Cap
8 x 1/2 Ty "AB"
Pan Head Screw
Rear
Stop Washer
Wire Tie
34
#10 External
Lockwasher
Plastic End Caps
Bracket
Lockwasher
10-32 x 3/8 Pan
Head Screw
Rear End
Cap
Wire Tie
Two Cords