Mounting The Motor - RIDGID TS3612 Owner's Manual

4. Place rip fence on the right hand side of
table. Carefully move it against blade
so that it is parallel to the blade, and
just touches tips of saw teeth. Tighten
rip fence lock lever.
5. Insert folded paper between spreader
and fence.
6. Using 7/16 wrench loosen the 1/4-20
hex head screws so the spreader can
slide sideways.
7. Hold spreader flat against folded paper
and fence. Tighten screws using 7/16
inch wrench.
8. To remove blade guard and spreader,
loosen thumbscrew. Do not loosen
other screws. This allows you to
remove and replace the guard for non-
through cuts without disturbing the
spreader alignment.

Mounting the Motor

1. Remove Motor Assembly from motor
carton.
2. Loosen the two hex head screws that
lock the pins in the cradle.
3. Lift motor and insert the two pins on
motor support assembly into holes in
cradle. Push motor in as far as it will go.
Do not tighten screws at this time.
7/16 In.
Wrench
Pins
Motor Support
Assembly
37
Folded Paper
Hex Head Screws
Motor
Hex Head Screws
Cradle