Mounting Switch And End Caps - RIDGID TS3612 Owner's Manual

2. Lower blade all the way down and
remove the motor belt.
3. Install one flat washer onto each of
the four motor studs.
4. Open the hinged belt guard by press-
ing down on the tab lock as shown.
5. Position the guard so the large hole
fits around the pulley. Insert the motor
studs through the four small holes as
shown.
6. Attach another washer and one nut to
each motor stud as shown and
tighten securely.
7. Reposition the belt on the motor and
arbor pulley.
8. Close the hinged cover securely until
the tab snaps and locks the cover
closed.
9. Check the belt clearances on the
guard by raising the blade to full
height using the elevation handwheel.
10. Check motor clearances by rotating
the bevel handwheel located on the
right side until the indicator is set at
45°.

Mounting Switch and End Caps

1. From the bag labeled "Miscellaneous"
remove only the following hardware:
2 Pan Head Screws, 10-32 x 3/8" Long
2 Lockwashers, #10 External Type
2 Square Nuts, 10-32
6 Pan Head Screws, Type "AB" 8 x 1/2"
Long
From the bag labeled "Trim" remove the
following:
4 Plastic End Caps
1 Key Switch
2. Insert the 2 10-32 x 3/8" pan head
screws with lockwashers through the
outermost holes in switch assembly.
3. Install the 2 square nuts on the screws
so that there is an 1/8"+ clearance
between the inside of the nut and the
top of the switch assembly bracket.
NOTE: Switch assembly may be mounted
on left or right hand side of saw.
Motor Flat
Stud
Washer
Pan Head Screw
Type "AB" 8 x 1/2
10-32 x 3/8"
Pan Head Screw
Square Nut
Front Guide
Bar
Switch Assembly
39
Flat
Washer
#10 External
Square Nut
Lockwasher
Key Switch
Plastic End Caps
Bracket
Lockwasher
10-32 x 3/8 Pan
Head Screw
Belt
Guard
Hex Nut
10-32