Assembly (continued)
Installing Guide Bar End Caps
1. The left and right end caps for front guide bar can be
installed at this time. Align the plastic end cap to match
profile of bar.
2. Install self tapping 8-32 pan head screw into each hole.
3. The left and right end caps for rear guide bar can be
installed at this time.
NOTE: Two large washers are supplied. These act as
fence stops so the rear of the fence does not fall off the
rear guide bar.
4. Install rear end caps and fence stops as shown.
NOTE: This completes the assembly of your table saw.
Do not throw away any remaining hardware until you
have read the entire owners manual.
Front End
Cap
8 x 1/2 Ty "AB"
Pan Head Screw
Rear
Stop Washer
34
Rear End
Cap