Operating Units Individually; Operating All Units By Tenant - Panasonic CZ-256ESMC2 Operation Manual

6 Using the System

6.4.1.1 Operating units individually

Use this screen to operate individual indoor units.
Procedure
Select 1.Status/Control in the main menu and 1.Each tenant in the sub menu.
1 When you touch the unit that you want to set, a remote control window for individual on/off
operations appears.
2 When you touch , a remote control window appears. This window allows you to
make detailed settings for operations on individual units.
1.Status/Control
2.Total data/Cut-off 1.Each tenant
3.Distrib. ratio/Usage 2.Each tenant details
4.Maintenance/Test Run 3.Each zone
4.Each zone details
5.Initial settings
5.All units
6.Auxiliary settings
1
a. Closes the remote control window.
b. Sets to either Start or Stop.
c. Sets the operating mode.
d. Set the temperature.
e. Sets the fan speed.
f. Sets the fan direction. This setting is applied to
the entire group. You cannot change the sub
unit setting independently.
g. Sets and cancels timer operation.
h. Sets timer number from No. 1 to No. 50.
• For multiple units, the operation mode for one unit may not be varied while another indoor unit is under
operation. In such a case, once stop the unit, hold it for several minutes, and then vary the operation
mode.
• In the remote control window, the rst 16 characters for tenant names and the rst 12 characters for unit
names are displayed.
32
1 1
1 1
Main Sub
a
b
c
d
e
f
g
h
i
j
l
2 k
Move the display position on the
screen up and down one line.
i. Displays a window that allows you to check timer
setting status and remote control prohibition
status.
j. Displays one of "Prhbt1/ Prhbt2/ Prhbt3/ Prhbt4/
Accept".
k. Turns the ventilation function ON and OFF. (You
cannot press the button when air conditioners
have no ventilation functions).
l. Resets lter cleaning signs.
6 Using the System

6.4.1.2 Operating all units by tenant

Use this screen to operate all connected indoor units of each tenant.
Procedure
Select 1.Status/Control in the main menu and 1.Each tenant in the sub menu.
1 When you touch a tenant name, a remote control window appears. This window allows you to
perform on/off operations for all units of the tenant.
2 When you touch , a remote control window appears. This window allows you to
make detailed settings for operations on all units of the tenant.
1.Status/Control
2.Total data/Cut-off 1.Each tenant
3.Distrib. ratio/Usage 2.Each tenant details
3.Each zone
4.Maintenance/Test Run
5.Initial settings 4.Each zone details
6.Auxiliary settings 5.All units
1
1
2
33
1 1 1 1
Main Sub
2