Setting Tenant Names And Distribution Groups; Main Sub - Panasonic CZ-256ESMC2 Operation Manual

6 Using the System

6.3.4 Setting tenant names and distribution groups

Use this screen to set tenant names and distribution groups.
You can also use this screen to set the product type (PAC, GHP, HOT, etc.) of indoor units.
Procedure
Select 5.Initial settings in the main menu and 3.Ten. name/Distrib. Gr. in the sub menu, then
proceed as follows.
1.Status/Control
2.Total data/Cut-off 1.Date/Distrib.
3.Distrib. ratio/Usage 2.CNTR/Unit/Ten. No.
4.Maintenance/Test Run 3.Ten. name/Distrib. Gr.
5.Initial settings 4.Pulse meter setting
6.Auxiliary settings 5.Clear accum. data
1 2
1 Touch a tenant name. A keyboard window appears. Use the keyboard to enter the tenant name.
Tenant names can be up to 20 characters long.
* See "7 Entering Text and Numbers" for details about entering text on software keyboards.
* The tenant number range is from 1 to 256.
26
5 3
5 3
6 Using the System
Main Sub
2 Touch a distribution group. A keyboard window like the one shown above appears. Use the keyboard
to enter a distribution group number and to select the product type from among PAC, GHP and HOT.
Select "Simple" or "Load" in the distribution methods.
* Refer to "10. Calculating air conditioner distribution" for details.
The tenant set at "Load" distribution will have its "No" box display in light blue.
* The distribution group number range is from 1 to 8.
* This button is invalid when "No Distrib." has been set. (Refer to
* The distribution group column set at loaded distribution has no product type such as "PAC" and "GHP"
displayed.
* Make manual cut-off in advance to change the distribution method.
3 Press the Type button to select "PAC" or "GHP" for the following unit that is unable to
automatically recognize product type.
- Interface Adaptor
This is only for "Simple distribution" setting.
4 Specify which distribution method, "Simple" or "Load," to apply to the selected distribution group.
5 Touch Set to con rm the setting, or Cancel to cancel it.
5
3
4
• PAC, GHP, and HOT cannot be mixed in the same group. Set up a separate distribution group for each
type.
• HOT multi units cannot be recognized automatically (they are recognized as PAC). Manually set the
product type to HOT.
• HOT Tenants cannot be set at the "Load" distribution.
• "Load" distribution tenants cannot be set at "HOT".
• Air conditioners unadaptable to loaded distribution cannot be set at "Load" Distribution.
• Interface Adaptors are also unadaptable to loaded distribution.
5 3
5
Main Sub
5 1
5 1
Main Sub
)
27
3