Clear Accumulation Data; Main Sub; Status Monitoring And Operation Screens; Displaying General Information By Tenant - Panasonic CZ-256ESMC2 Operation Manual

6 Using the System

6.3.6 Clear accumulation data

Use this screen to erase total data after test runs, and to restart total calculations for operating
time, operating counts, and so on.
Procedure
Select 5.Initial settings in the main menu and 5.Clear accum. data in the sub menu, then
proceed as follows.
1.Status/Control
1.Date/Distrib.
2.Total data/Cut-off
3.Distrib. ratio/Usage 2.CNTR/Unit/Ten. No.
4.Maintenance/Test Run 3.Ten. name/Distrib. Gr.
5.Initial settings 4.Pulse meter setting
6.Auxiliary settings 5.Clear accum. data
1 Touch Clear accum. data .
A window like the following appears.
Touch Yes . Total data up to now is erased, and
calculation of total operating time restarts.
30
5 5
5 5
6 Using the System
Main Sub

6.4 Status Monitoring and Operation Screens

6.4.1 Displaying general information by tenant

Use this screen to display information about all connected indoor units by tenant.
Procedure
Select 1.Status/Control in the main menu and 1.Each tenant in the sub menu.
The indoor units for each tenant are displayed.
1.Status/Control
2.Total data/Cut-off
3.Distrib. ratio/Usage
4.Maintenance/Test Run
5.Initial settings
6.Auxiliary settings
1
1 Scrolls the display one tenant at a time.
2 Scrolls the display one row at a time.
Meaning of symbols
"---" is displayed in the tenant name row for indoor units not registered to a tenant.
The rst 12 characters are displayed for tenant names and unit names.
If an Interface Adaptor is used, the color becomes light purple during the ON operation.
1.Each tenant
2.Each tenant details
3.Each zone
4.Each zone details
5.All units
1 2
: COOL : DRY : FAN
: AUTO Mode/Speed : SWING
: Accept remote controller : Prohibit remote controller setting No.1
: TIMER
: Medium fan speed : Low fan speed
31
1 1 1 1
Main Sub
Tenant name
: HEAT : ALARM
: VENTILATION
: High fan speed
: Clean filter sign