8
6
5
4
7
3
2
–
Loosen screw at the motor coupling 7.
–
Push arm shaft cam 6 axially to the right as far as it will go.
–
Push adjusting ring 3 to the left against the bearing bush and
tighten screws.
–
Check arm shaft with regard to axial backlash and smooth running.
–
Tighten screws at the thread trimmer cam 2
(adjustment see chapter 5).
–
Tighten screws at the bevel gear 4
(adjustment see chapter 2.2).
–
Tighten screws at the bobbin winder wheel
(adjustment see chapter 2.3).
–
Tighten screw at the motor coupling 7
(adjustment see chapter 2.6 ).
3
3
7