Section 9-Headrest; Removing/Installing/Adjusting Headrest - Invacare Formula Powered Seating Owner's Operator And Maintenance Manual

SECTION 9—HEADREST
SECTION 9—HEADREST
After ANY adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
If using a ventilator, verify headrest support does not interfere at ALL angles. Oth-
erwise, injury or damage may occur.

Removing/Installing/Adjusting Headrest

NOTE: For this procedure, refer to FIGURE 9.1.
Removing
1. Loosen, but DO NOT remove, the
thumb screw that secures the headrest
to the headrest mounting bracket.
2. Remove the headrest from the headrest
mounting bracket.
Installing
1. Make sure thumb screw is loose.
2. Install the headrest until the headrest
stop sits on the headrest mounting
bracket.
3. If necessary, adjust the height, depth or
direction of the headrest. Refer to
Adjusting Headrest Height on page 61
or Adjusting Headrest Depth/Direction
on page 61.
Formula™ Powered Seating
All manuals and user guides at all-guides.com
WARNING
CAUTION
60
Slide
Offset Fixture
Tube
Socket
Screws
Height
Adjustment
Thumb
Screw
FIGURE 9.1 Removing/Installing/Adjusting
Headrest
Depth
Adjustment
Set Screw
Headrest
Mounting
Bracket
Headrest Stop
Part No 1122170