Sensor (Tray 2 Feed-Out) On Jam - Lexmark W840 Service Manual

4024-XXX
Step
13 Perform a print test.
Does the error still occur?

245.01 Sensor (tray 2 feed-out) on jam

Step
1 Check the paper path.
Open the HCF top door assembly
Open the HCF media feed unit assembly.
Check these items by turning them with your fingers.
Are the pick roll, feed roll, separation roll, HCF media
transport roll assembly, and roll attached on the HCF
top door assembly installed correctly?
2 Are the pick roll, feed roll, separation roll, HCF media
transport roll assembly, and roll attached on the HCF
top door assembly free of excess wear and
contamination?
3 Check the sensor (tray 2 feed-out) on the printer for
proper operation.
1. Enter Diagnostics mode.
2. Select INPUT TRAY TESTS.
3. Select Sensor Tests.
4. Select Tray 2.
5. Select Feed-out.
Open the printer left lower door assembly.
Does the display on the operator panel change, every
time a piece of white paper is placed over the sensing
area of the above sensor?
2-72
Options Service Manual
Check
Check
Yes
Replace the printer Problem solved.
engine card
assembly.
Refer to the Printer
Service Manual.
Yes
Go to step 2. Clean or replace the
appropriate roll, and
clean the paper
path.
Go to
roll assembly
removal" on
page
feed roll assembly
removal" on
page
separation roll
assembly removal"
on page
"HCF media
transport roll
assembly removal"
on page
Go to step 3. Clean or replace the
appropriate roll, and
clean the paper
path.
Go to
roll assembly
removal" on
page
feed roll assembly
removal" on
page
separation roll
assembly removal"
on page
"HCF media
transport roll
assembly removal"
on page
Go to step 5. Go to step 4.
No
No
"HCF pick
4-142, "HCF
4-143, "HCF
4-145, and
4-149.
"HCF pick
4-142, "HCF
4-143, "HCF
4-145, and
4-149.