Replacing The Bulb For The Licence Plate Light; Rear Light - Skoda Rapid Owner's Manual

›
Attach the connector.
Refit the headlight and grille
›
Replace the fog light by inserting it in the opposite direction of the arrow
» Fig. 158 and tightening.
4
›
Insert the protective grille and carefully press it in.
The protective grille must engage firmly.

Replacing the bulb for the licence plate light

Fig. 159 Remove the number plate light/replace the bulb

Read and observe and
›
Open the boot lid.
›
Push in the lamp in the direction of the arrow
The lamp comes loose.
›
Swivel out the lamp in the direction of the arrow
›
Remove the faulty bulb from the holder in the direction of the arrow
›
Insert a new bulb into the holder.
›
Reinsert the lamp in the opposite direction to the arrow
›
Push on the light until the spring clicks into place.
Check that the light is securely inserted.
on page 172 first.
» Fig. 159.
1
and remove it.
2
.
1

Rear Light

Fig. 160 Remove light / pull out connector

Read and observe
Removing
›
Open the boot lid.
›
Insert the clamps for removing the full wheel covers
kit into opening
A
.
3
›
Remove the cover by pulling the hook in the direction of arrow
›
Unscrew the screws
›
Grasp the lamp and carefully remove in the direction of arrow
›
Press the latch on the connector in the direction of arrow
›
Carefully remove the connector from the tail lamp assembly in the direction
of the arrow .
4
Fitting
›
Insert the bulb holder into the lamp.
The lock on the plug must be inserted securely.
›
Insert the lamp with the pin
» Fig. 160 in the body.
C
and on page 172 first.
» Fig. 160.
with the key from the tool kit.
B
» Fig. 161 on page 176 into the recesses
B
Fuses and light bulbs
» page 155, Vehicle tool
.
1
.
2
.
3

175