Automatic connection
The connection to SmartGate is automatically restored under the following
conditions.
Wi-Fi is turned on in the device to be connected.
The ignition is switched on.
The device to be connected stores the password required for the connec-
tion check.
Connection problems
If the connection fails, check the following points.
›
Are the conditions for a successful connection fulfilled?
›
Is Smart Gate available in the list of available Wi-Fi networks?
›
Has the password required for the connection check been entered?
›
Is the password is required for the connection check correct?
›
Is the device to be connected still connected to another Wi-Fi network?
If the above items are ok but the connection still fails, contact a ŠKODA part-
ner.
Note
Up to four devices can be connected to SmartGate at a time.
Smart Gate website
Read and observe
on page 98 first.
There is a special website for the SmartGate system.
The following address must be entered in the web browser of the connected
device.
HTTP://192.168.123.1
This website contains information about the vehicle, the Wi-Fi connection and
SmartGate.
In the Configuration area the Wi-Fi connection settings can be adjusted.
Save the setting changes
The setting changes are only applied after performing the following steps.
›
The changes are saved by pressing the "Save" button.
›
SmartGate is restarted by pressing the "Reboot "button.
Password Management
Read and observe
on page 98 first.
Password management can be done in the connected device on the Smart-
Gate
website» page
99, Smart Gate website.
The changes are applied after saving and restarting SmartGate
Save the setting changes.
Change password
›
Enter a new password in the Configuration area in menu option WPA / WPA2
key.
The password must be 8-17 characters without diacritics or special characters
(for example, -, /, etc.).
Connection option without entering a password
›
In the Configuration area set the value Open in the menu item Security .
Forgot password
If you have forgotten your password, SmartGate must be reset to factory set-
tings in a specialized workshop.
» page
99,
Communication and multimedia
99