Service Interval Display - Skoda Rapid Owner's Manual

Note
If warning messages are displayed, these messages must be verified to ac-
■
cess the main menu » page 42, Using the information system.
If the display is not activated at that moment, the menu always shifts to one
■
of the higher levels after approx. 10 seconds.
Using the factory-fitted radio or navigation system
■
structions or» navigation system operating instructions.
Settings

Read and observe on page 46 first.
You can change certain settings by means of the MAXI DOT display. The cur-
rent menu item is shown in the top of the display under a line.
The following information can be selected (depending on the equipment in-
stalled in the vehicle).
Language
You can set the language for the display texts here.
MFD data
Activate or deactivate certain displays of the multifunction display here.
Time
The time, time format (12 or 24 hour indicator) and the changeover between
summer/winter time can be set here.
Winter tyres
Here, the speed and the switching on and off of the acoustic signals when ex-
ceeding this speed can be adjusted. This function is, for example, used for win-
ter tyres where the maximum permissible speed is lower than the maximum
speed of the vehicle » page 148, Tyres and wheel rims.
As soon as the parking procedure is completed, an audible signal sounds and
the following message appears in the information display.
Winter tyres: max. speed ... km/h.
Units
The units for the temperature, consumption and distance driven can be set
here.
1)
For models with the speedometer in mph, the second speed is displayed in km/h.
Alt. speed dis.
Here, the display of the second speed in mph
Further information
Service
The days and kilometres remaining until the next service can be displayed
» Radio operating in-
here.
Factory setting
The display functions can be restored to their factory settings here.
Compass point display

For vehicles with a factory fitted navigation system, an abbreviation for each
point of the compass (depending on the current direction of travel) is shown
on the top left-hand corner of the display.
The compass point display only operates when the ignition is switched on.

Service interval display


This chapter contains information on the following subjects:
Prompt in the MAXI DOT display
Prompt in the segment display
Resetting the service interval display
The service interval display shows the time and mileage to the next service
event.
The service due date is automatically displayed on the display and this infor-
mation can be displayed manually if necessary.
The kilometre indicator or the days indicator reduces in steps of 100 km or,
where applicable, days until the service due date is reached.
The information regarding the service intervals can be found in the service
schedule.
» page 33, Display of the second speed.
Read and observe on page 46 first.
Introduction
can be activated.
1)
48
48
49
47
Information system
