Indicator Lights; Too Hot - Skoda Rapid Owner's Manual
Hide thumbs
Also See for Rapid:
- Owner's manual (230 pages) ,
- Operating instructions manual (196 pages) ,
- Owner's manual (124 pages)
Table of Contents
Advertisement
Some error messages and other information are displayed in the MAXI DOT
display. The messages are displayed simultaneously with the icons in the MAXI
DOT display or with the warning lights in the instrument cluster
Indicator lights.
The menu item Vehicle status is shown in the main menu of the MAXI DOT
display whenever at least one fault message exists. After selecting this menu,
the first of the error messages is displayed.
If there are several error messages, the display will show 1/3, for example, be-
low the message. This indicates that the first of a total of three error messag-
es is being displayed.
Warning symbols in the MAXI DOT display
Engine oil pressure too low
Check engine oil level,
Problem with the engine oil pressure
Clutches of the automatic DSG gearbox are
Problem with the engine oil pressure
If the
symbol is shown in the MAXI DOT display, you must have your vehicle
checked immediately by a specialist garage. The information about the maxi-
mum permissible engine speed is displayed together with this symbol.
Clutches of the automatic DSG gearbox are too hot
A
symbol in the MAXI DOT display indicates that the temperature of the au-
tomatic gearbox DSG clutches is too high.
The following message is shown in the MAXI DOT display.
Gearbox overheated. Stop! Owner's manual!
do not continue to drive! Stop the vehicle, switch off the engine, and wait
until the
icon goes out - risk of gearbox damage! You can continue your
journey as soon as the symbol disappears.
34
Using the system
WARNING
If you have to stop for technical reasons, then park the vehicle at a safe
» page
34,
distance from the traffic, switch off the engine and switch on the hazard
Note
If the MAXI DOT display shows warning messages, these messages must be
■
confirmed in order to access the main menu
system .
As long as the operational faults are not rectified, the symbols are always in-
■
dicated again. After they are displayed for the first time, the symbols continue
to be indicated without any extra messages for the driver.
» page 36
Indicator lights
Introduction
» page 34
This chapter contains information on the following subjects:
» page
» page
42, Using the information
35
35
35
35
36
36
36
37
37
37
37
38
38
38
38
38
38
39
39
Hide quick links:
Advertisement
Chapters
Table of Contents
