Fig. 28; Memory; Multifunction Display - Skoda Rapid Owner's Manual

The multifunction display only operates when the ignition is switched on. After
the ignition is switched on, the function that was last selected before switch-
ing off the ignition is displayed.
For vehicles with a MAXI DOT display, the menu item MFD must be selected
and confirmed in the main menu
On vehicles with a MAXI DOT display, there is an option to fade out some of
the information » page 47, Settings.
WARNING
Concentrate fully on your driving at all times! As the driver, you are fully
■
responsible for the operation of your vehicle.
Even at outside temperatures of around +4 °C, black ice may still be
■
present on the road surface! You should therefore not rely solely on the
outside temperature display for an indication of whether there is black ice
on the road.
Note
In certain national versions the displays appear in the Imperial system of
■
measures.
If the display of the second speed is activated in mph, the current speed is
■
not indicated in km/h on the display.
The amount of fuel consumed will not be indicated.
■

Memory

Fig. 28

Multi-function display - memory display

Read and observe on page 44 first.
In memory the values of elements of the multifunction display(e.g. average
fuel consumption) are recorded.
The multifunction display is equipped with two memories, 1 and 2.
44
Using the system
» page 46, MAXI DOT display.
Display of the selected memory in the display at the position
Single-trip memory

Total trip memory

Select memory
›
Select the corresponding element of the multifunction display
Information overview.
›
Confirm details again to select the desired memory.
Reseting
›
Select the corresponding element of the multifunction display
Information overview.
›
Select the desired memory.
›
Press and hold to confirm the selected memory.
Single-trip memory (memory 1)
The single-trip memory collates the driving information from the moment the
ignition is switched on until it is switched off.
New data will also flow into the calculation of the current driving information if
the trip is continued within 2 hours after switching off the ignition.
If the trip is interrupted for more than 2 hours, the memory is automatically
erased.
Total-trip memory (memory 2)
The total-trip memory gathers data from any number of individual journeys up
to a total of 19 hours and 59 minutes or 1 999 kilometres driven (), and a total
of 99 hours and 59 minutes or 9 999 kilometres driven ().
The memory is deleted when either of these limits is reached and the calcula-
tion starts all over again.
Unlike the single-trip memory, the total-trip memory is not deleted after a pe-
riod of interruption of driving of 2 hours.
The following values of the selected memory are set to zero.
›
Average fuel consumption.
›
Distance driven.
›
Average speed.
›
Driving time.
Note
Disconnecting the vehicle battery will delete all memory data.
» Fig. 28
A
» page 45,
» page 45,