Replacing The Bulb For The Fog Light; Replacing The Bulb For The Licence Plate Light - Skoda Citigo Operating Instructions Manual

›
Pry the flashing light from the body in the direction of arrow
side of the vehicle mirror).
›
Remove the bulb holder in the direction of arrow.
3
›
Remove the faulty bulb from the socket.
›
Insert a new bulb into the socket.
›
Replace the bulb holder.
›
Set the side repeater turn signal light with the side facing the rear of the ve-
hicle in the body and lightly press it until the spring on the other side of the
side repeater turn signal light latches.

Replacing the bulb for the fog light

Fig. 133 Light bulb for fog lights

Read and observe and
›
Use the on board tool to remove screws
›
Unscrew rivet with a flat, blunt object such as a coin.
B
›
Push the battery cover in the direction of the arrow .
›
Remove connector .
C
›
Turn the connector with the bulb in an anti-clockwise direction up to the
stop and remove .
›
Turn the connector with the new bulb into the headlight and turn in a clock-
wise direction as far as the stop.
›
Attach the connector until it clicks firmly into place.
›
Fold the wheel house trim back.
›
Insert the expanding rivet again and screw in.
B
›
Firmly tighten the two attachment bolts
138
Do-it-yourself
2
on page 136 first.
» Fig. 133 from the wheel well.
A
with the screwdriver.
A
(on the right

Replacing the bulb for the licence plate light

Fig. 134 Remove the number plate light/replace the bulb

Read and observe
›
Insert a slotted screwdriver into the gap in the arrow area
remove the lamp.
›
Remove the lamp from the bumper.
›
Turn the bulb holder anti-clockwise and remove in the direction of the arrow
» Fig. 134 - .
›
Remove the faulty bulb from the socket.
›
Insert a new bulb into the socket.
›
Replace the holder with the bulb into the lamp housing and turn in a clock-
wise direction to the stop.
›
Insert the light into the opening of the bumper with its left edge. Lightly
press it until the spring latches.
CAUTION
Ensure that the vehicle paintwork and the tail lamp are not damaged when re-
moving and installing the tail lamp.
and on page 136 first.
» Fig. 134 -  and