Yamaha FZS1000N Service Manual page 61

T Fasten the ignition coil lead and frame cross pipe
with a plastic clamp. Do not fasten the red / black
lead and orange lead.
U Fasten the handlebar switch lead (left / right), main
switch lead, EXUP servo motor lead, fan motor lead
and thermo unit lead with a plastic clamp. Locate
the end of clamp to downward. Ensure that the
throttle cable and high tension cable do not come
into contact with each other.
V Fasten the rectifier / regulator stay and rectifier / reg-
ulator lead with a plastic clamp.
W Route the wire harness under the rectifier/regulator.
X Fasten the battery negative lead with a battery
band.
Y Insert the ground lead coupler in the battery band.
Z Fasten the taillight lead and flasher light lead, and
put in the groove on the taillight bracket.
CABLE ROUTING
AA Put the seat lock cable into the groove on the rear
fender.
AB Fasten the battery positive lead with a plastic band.
2-42
SPEC