Installing The Handlebar - Yamaha FZS1000N Service Manual

HANDLEBAR
3.Install:
S handlebar grip
a. Apply a light coat of rubber adhesive onto the
left end of the handlebar.
b. Slide the handlebar grip over the left end of
the handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
WARNING
Do not touch the handlebar grip until the
rubber adhesive has fully dried.
EAS00672

INSTALLING THE HANDLEBAR

1. Stand the motorcycle on a level surface.
WARNING
Securely support the motorcycle so that
there is no danger of it falling over.
2. Install:
S handlebar 1
S upper handlebar holders 2
CAUTION:
S First, tighten the bolts on the front side of
the handlebar holder, then on the rear side.
S Turn the handlebar all the way to the left
and right. If there is any contact with the
fuel tank, adjust the handlebar position.
NOTE:
Align the match marks a in the handlebar with
the upper surface of the lower handlebar hold-
ers.
3. Install:
S throttle grip 1
S throttle cables
NOTE:
Align the pins a on the right handlebar switch
with the holes b in the handlebar.
4-58
CHAS
23 Nm (2.3 mSkg, 17 ftSlb)