Yamaha FZS1000N Service Manual page 273

Hide thumbs Also See for FZS1000N:

Table of Contents

CRANKSHAFT JOURNAL BEARING

crankshaft-pin-to-big-end-bearing

Out of specification ! Replace the big end

Crankshaft-pin-to-big-end-bearing

0.031 X 0.055 mm

(0.0012 X 0.0022 in)

The following procedure applies to all of the

connecting rods.

Do not interchange the big end bearings and

connecting rods. To obtain the correct

crankshaft-pin-to-big-end-bearing

ance and prevent engine damage, the big

end bearings must be installed in their origi-

nal positions.

a. Clean the big end bearings, crankshaft pins,

and bearing portions of the connecting rods.

b. Install the big end upper bearing into the con-

necting rod and the big end lower bearing

into the connecting rod cap.

Align the projections a on the big end bearings

with the notches b in the connecting rod and

connecting rod cap.

Chapters

Table of Contents