Installing The Clutch - Yamaha FZS1000N Service Manual

CLUTCH
4. Check:
starter clutch operation
a. Install the starter clutch drive gear 1 onto
the starter clutch 2 and hold the starter
clutch.
b. When turning the starter clutch drive gear
clockwise A , the starter clutch and the start-
er clutch drive gear should engage.
If the starter clutch drive gear and starter
clutch do not engage, the starter clutch is
faulty and must be replaced.
c. When turning the starter clutch drive gear
counterclockwise B , it should turn freely.
If the starter clutch drive gear does not turn
freely, the starter clutch is faulty and must be
replaced.
EAS00299

INSTALLING THE CLUTCH

1. Install:
clutch housing
NOTE:
Make sure that the slots a in the clutch hous-
ing align with the tabs b on the oil/water pump
assembly drive sprocket.
Make sure that the primary driven gear teeth
and primary drive gear teeth mesh correctly.
Make sure that the starter clutch gear teeth and
starter clutch idle gear teeth mesh correctly.
2. Install:
lock washer
New
clutch boss nut 1
NOTE:
While holding the clutch boss 2 with the univer-
sal clutch holder 3 , tighten the clutch boss nut.
Universal clutch holder
YM-91042
5-45
ENG
90 Nm (9.0 m kg, 65 ft lb)