Setting The User Information - Panasonic HC-X1000 Operating Instructions Manual

≥ The time code will reset when the built-in lithium battery is exhausted when it is set to
[FREE RUN].
[TC PRESET]
You can set the initial time code.
1
Select the menu.
MENU
: [TC/UB SETUP] # [TC PRESET]
2
Touch the item to set and change with
≥ It will be set to 00h00m00s00f when the RESET button is pressed.
≥ "h" is an abbreviation for hour, "m" for minute, "s" for second and "f" for frame.
3
Touch [ENTER].
≥ Touch [EXIT] to complete the setting.
≥ This unit will adjust the time code in accordance with the frame rate of the [REC FORMAT].
(l 139) Therefore, it may not be continuous from the previous final time code when the recording
format is changed.
≥ If the frame rate in [REC FORMAT] is set to 24p, set the number of frames to [00] or a multiple of
4. If you enter a different value, time code will not be recorded correctly.

Setting the User Information

Eight digit hexadecimal alphanumeric can be entered and displayed as a memo information such as
dates, control numbers, etc., into the User Information.
UB 00 00 00 00
≥ This is displayed only when [REC MODE] is set to [AVCHD].
[UB PRESET]
You can set the User Information.
≥ Set [REC MODE] to [AVCHD].
1
Select the menu.
MENU
: [TC/UB SETUP] # [UB PRESET]
2
Touch the item to set and change with
≥ You can use numbers from 0 to 9 and letters from A to F.
≥ It will be set to 00 00 00 00 when the RESET button is pressed.
3
Touch [ENTER].
≥ Touch [EXIT] to complete the setting.
(l 139)
- 59 -
/ .
(l 139)
/ .