Adjusting The Audio Input Level - Panasonic HC-X1000 Operating Instructions Manual

To remove the external microphone, etc., from the audio input terminals 1, 2
(XLR 3 pin)
Remove while pushing on the PUSH section of the audio
input terminals 1, 2 (XLR 3 pin).
≥ Set the input signal to built-in microphone by switching
the CH1, CH2 switches to INT (L) or INT (R) after
removing the external microphone. Audio will not be
recorded when motion picture is recorded without
switching.
≥ Set INPUT1, 2 (+48V) switches to LINE or MIC if you connect equipment not compatible
with +48 V. You can damage this unit or such equipment if you leave the setting at +48V.
≥ This unit is turned off when a problem occurs with the +48 V power supply.
≥ The battery will discharge faster if you use a phantom microphone.

Adjusting the audio input level

Selecting an adjustment method
You can select how to adjust the audio input level. For audio channel 1, select [AUDIO LEVEL
CH1]; for audio channel 2, select [AUDIO LEVEL CH2].
1
Select the menu.
MENU
: [RECORD SETUP] # [AUDIO LEVEL CH1] or [AUDIO LEVEL CH2] # desired setting
[AUTO]
:
[MANUAL]
:
2
(If you have touched [MANUAL])
Adjust the input level operating the Audio control knobs (CH1, CH2)
Adjusts the level automatically.
Adjusts the level manually.
- 55 -
A PUSH section