4 - 16 Omnii Hand-Held with Windows CE 6.0 User Manual
Operator Controls
The ST4004 has no operator controls or power switch.
Indicators
The quad docking station is equipped with Ethernet activity and link LEDs (see
connection on page
Quad Docking Station Operation
Charging the Omnii Battery
•
Insert the DC power plug into the ST4004 rear DC IN connector (see
connection on page
IMPORTANT
The ST4004 supplies DC power to enable the Omnii internal fast charger. Normally, a full charge of the battery
will take from 3 to 4 hours.
•
Insert up to four Omnii computers into the docking station charging bays, pressing down gently but firmly to
seat them securely.
•
During the charge, the Omnii LED slow flashes green.
•
When the battery finishes charging, the LED turns solid green.
•
To remove the Omnii, push down on the release mechanism on the front face of the docking bay. The
hand-held will detach from the docking bay release arms and can be pulled up and out.
NOTE
Battery charging continues whether the Omnii is switched on or off.
Insertion and removal of Omnii computers
Figure 4-13
4-17).
4-17).
Use IEC-320 C13 power cords approved by Motorola, with the ground pin
connected to a proper earth-grounded receptacle. Check with a qualified
electrician if you are uncertain of your receptacle grounding.
Figure 4-14 Ethernet network
Figure 4-14 Ethernet network
Release arm
Release mechanism