Add And Edit Trigger Mapping - Motorola 7545MBW User Manual

3 - 42 Omnii Hand-Held with Windows CE 6.0 User Manual

Add and Edit Trigger Mapping

These dialogs allow you to add and edit trigger mappings.
Trigger Key
This drop-down list allows you to specify the source of the trigger events, such as the Soft Scan, Left Scan,
etc., for the trigger module selected.
NOTE
It is possible to map the same source to different modules (trigger consumers)
— for example, to both the Imager and Non-Decoded Scanner. If so, both
devices/operations will occur simultaneously. This is not recommended in most
cases, especially with devices such as Imagers or RFID Readers.
It is also possible to map different sources to the same module (trigger con-
sumer) — for example, two different trigger keys can be mapped to the RFID
File System.
Add Key
Only existing trigger sources are shown in the Source combo-box. To add a new source to this list, tap on the
Add Key button. A dialog will pop up and allow you to select the keyboard key to use as a trigger source.
Trigger-Press Type
You can enable either an Up/Down or Double Click response to a trigger press. Normally, when a trigger
(keyboard key, etc.) is pressed and released, a "trigger down" event is sent to the owner — that is, the applica-
tion receiving the trigger press information — followed by a "trigger up". If Double Click is chosen in this menu,
when the trigger is pressed, released, and then pressed again, a "double-click" event will have occurred. If a
mapping with the type Up/Down has also been configured for the same source, it will only receive the first set
of trigger events.